Home Give Back DIY Single Shooting Bench
Give Back

DIY Single Shooting Bench

by Jack Sander
written by Jack Sander 0 comments 604 views 1 minutes read

 

I strongly encourage you to send photos with your projects built using my plans. Please send the materials at [email protected] or using the contact form. Any submission is highly appreciated by me and by the rest of the readers. In addition, your projects will be seen all around the world, so you can point out your skills. Don’t forget to mention the cost of the materials, the total time of the project as well as a few impressions about the build. 

 

 

DIY Single Shooting Bench

DIY-Single-Shooting-Bench

 

Built this right handed shooting bench using the plans on this website. The only change was that I used 1×12’s for the surface instead of plywood in order to keep the cost (and weight!) down. This also allows for a little overhang where your elbow rests. If opting to go this route, you will need 10′ of 1×12, and a 48″ 1×3, as 3 1×12’s are 2 3/4″ shy of covering the entire surface area. Cut two pieces of 1×12 to 31.5″, and one to 48″ Total cost was around $35.. would have been closer to $70 had I used 3/4″ plywood. Thank you for the plans, they were perfect!

By Matt

 

 

Difficulty Level: easy

Estimated Cost: $35

Time required: 1 weekend

From Plans: http://howtospecialist.com/workshop/free-shooting-bench-plans/

 

 

<b>PRINT PLAN<b> PRINT PLAN

EXPLORE MORE IDEAS:

 

You may also like

5×5 Deer Blind – DIY Project

Outdoor Wooden Outhouse – DIY Project

DIY 4×6 Shooting Stand

DIY Small Wood Shed

DIY 5×5 Deer Blind

12×20 Gable Shed – DIY Project

Leave a Comment

* By using this form you agree with the storage and handling of your data by this website.